replacing c-line

[sut]

hi

with your help on here i have managed to get multicas working with my cline.

problem i have now is i have a second cline i use on my eagle box upstairs ( this is different to what i currently have on my azbox )
tonight thou my channels stopped working so i changed cline takin the 1 upstairs and puttin it in my azbox following this section of a guide.

cccam.cfg will contain :
C: some.hostname.com 12000 username password
C: some.hostname.net 12001 username password
Transfer this file to : /PLUGINS/OpenXCAS/MultiCASRestart STB.
Now , enter Plug-ins -> OpenXCAS -> Camd Setup -> MultiCAS -> Smartcard Interface -> Smart Card Splitter & CS .
You will see Mode OFF
Use navigation buttons on RC and navigate on right side until You see :
Client CCcam .
Now scroll down to the Hostname and press Blue button and it will load for You C lines stored in cccam.cfg .
Press Red button to save, go to login and press OK if all is ok it will write for You login success , if not login fail.
Maybe when You load config it will go to Mode OFF but back on and data will be there.
That is all.

problem is this didnt work i restarted cam restarted box and nothing would work. what am i doing wrong here is anyone able to help please.

my cline reads as = C: 111111.dyndns.org 10000 anton 111 i think this is ok yes.

thx sut

[Pawnee]

Is the line still active in the eagle at the same time?

[sut]

hi

no when i changed c-line i remove ethernet connection to eagle box.

[Wint]

Is it big or small c: at the beginning it needs to be small, it look big in the example you give.

[sut]

no it is small.

[Pawnee]

A few things to clear up

Ok if it was working with your old line and then stopped there must be a problem elsewhere.

Did your old peer remove you from his share?

If yes to the above well the we know your setup is working and the problem is with the new config.

If you were not removed from the peers share there is something gone wrong with your internet connection or the cccam setup, I would check the connection and/or reinstall multicas.

If the problem is the new config double check the cccam.cfg, looking for extra spaces, correct ports and make sure the line ends after the password without extra spaces or characters eg yes or no at the end of the line..

[tomtosh]

Hi you can’t run two boxes at the same time turn one off power down not standby

[Pawnee]

Hi you can’t run two boxes at the same time turn one off power down not standby :confused:


Old thread m8