PDA

View Full Version : problems with multicas

yossarian31
21-10-09, 20:36
Format Application Area. Done

Flash with newest FW : 0.9.3501 Done

Connect on AzBox with FTP. Done

Enter in /PLUGINS directory and create there directory called OpenXCAS , so You will have /PLUGINS/OpenXCAS . Done

Inside of OpenXCAS , create file called module.seq . Done

Inside of /PLUGINS/OpenXCAS create directory MultiCAS , so You will have :

/PLUGINS/OpenXCAS/MultiCAS . Done

Put inside of MultiCAS folder file : emu_module ( MultiCAS 1.60 ). Done

On Your PC create file cccam.cfg with notepad++ ( This is very important that You use notepad++ because of linux letter formatting ).

like example :

cccam.cfg will contain :

C: some.hostname.com 12000 username password
C: some.hostname.net 12001 username password Done

Transfer this file to : /PLUGINS/OpenXCAS/MultiCAS Done

Restart STB.

Now , enter Plug-ins -> OpenXCAS -> Camd Setup -> MultiCAS -> Smartcard Interface -> Smart Card Splitter & CS .

You will see Mode OFF

Use navigation buttons on RC and navigate on right side until You see :

Client CCcam .

Now scroll down to the Hostname and press Blue button and it will load for You C lines stored in cccam.cfg . worked fine

Press Red button to save, go to login and press OK if all is ok it will write for You login success , if not login fail. login sucessful

Maybe when You load config it will go to Mode OFF but back on and data will be there.

That is all.

On Exit connect to All servers ? press Yes . Done

Enjoy. Cant as it still wont unscramble channels, cline works fine in eagle


any help appreciated at this stage
Pawnee
22-10-09, 06:02
Put inside of MultiCAS folder file : emu_module ( MultiCAS 1.60 ). Done

Did you chmod 755 this file?
Skytel
22-10-09, 08:32
have you also activated multicas by removing the hash
I have to reboot again afterwards if changing between cams
yossarian31
22-10-09, 15:28
Did you chmod 755 this file?

yes done that
yossarian31
22-10-09, 15:29
have you also activated multicas by removing the hash
I have to reboot again afterwards if changing between cams

only cam i have installed and i removed the hash
yossarian31
24-10-09, 11:52
Did you chmod 755 this file?


the only thing i can think of is the construction of my c line

can i send you my cline to make sure it is ok
Pawnee
26-10-09, 16:21
the only thing i can think of is the construction of my c line

can i send you my cline to make sure it is ok


Send me a pm and I will check it for you.