Tokala
31-12-08, 14:59
How To Setup Motor Position Diseqc 1.2
--------------------------------------------------------------------------------
This guide will briefly show you how to configure a none Usuals motor on your Eagle under the Diseqc 1.2 protocol.
1. Setup-Service Searching-Motor-Setup.
2. Untick GotoX.
3. Press blue button for next page.
4. Make sure top drop-down bar is in position mode.
5. Start at Left side of Arc and select say 45 east.
6. Scroll to direction drop-down bar.
7. Now use the <> buttons on your remote to find 45 east, if you don't make sure the transponder your on is a working one ( Check Lyngsat) and try again.
8. When you find the signal and confirm it is the correct orbital position press the green button to store it. On the pop-up store at position 1.
Now repeat all the above for the next orbital position say 42 east and sore at position 2, repeat until all orbital positions are covered.
Ferret
--------------------------------------------------------------------------------
This guide will briefly show you how to configure a none Usuals motor on your Eagle under the Diseqc 1.2 protocol.
1. Setup-Service Searching-Motor-Setup.
2. Untick GotoX.
3. Press blue button for next page.
4. Make sure top drop-down bar is in position mode.
5. Start at Left side of Arc and select say 45 east.
6. Scroll to direction drop-down bar.
7. Now use the <> buttons on your remote to find 45 east, if you don't make sure the transponder your on is a working one ( Check Lyngsat) and try again.
8. When you find the signal and confirm it is the correct orbital position press the green button to store it. On the pop-up store at position 1.
Now repeat all the above for the next orbital position say 42 east and sore at position 2, repeat until all orbital positions are covered.
Ferret